Wednesday, July 22, 2015

DIY Warrior Belle Hammer






We are going to make that hammer! First, a non comprehensive list of materials:

  • PVC pipe in length of your choice
  • Plexiglass
  • Silicone caulk
  • Plastic rose
  • Red LEDs
  • Soldering supplies (solder, iron, wire, ect.)
  • Fishing line
  • PVC primer and glue
  • Worbla
  • Battery stuff
  • On/off toggle switch
  • Misc bits of pipe
  • Instamorph or similar
  • Plastic primer
  • Paint
Now, let's get started!  The first thing you need to do is wire up your rose.  I only used two LED lights inside my rose petals, and I wish I had used more.  It wasn't quite bright enough.  I simply cut little slits into the petals and fed my LED light wires through.  Then, solder to wire, tape, pull down along stem.  Use florist green tape to hold in place.  Use spare wire to extend.  This wire bit needs to go all the way through your PVC pipe to connect to a toggle and battery at the bottom.

Unfortunately, if I took pics of these steps, I deleted them.

Now, set that aside and let's build the hammer.  Make a paper pattern for your large panes.  Cut out of plexiglass.







In one piece, cut out a hole the diameter of your PVC pipe.  If the glass splinters, drill tiny holes at the end of the splintering to stop it from spreading. Glue in your handle.  Make sure to use primer on both inner and outer, and glue on both inner and outer.  Shove into place quickly, the glue dries fast.



Using silicone caulk, glue the sides together.


Measure and cut out the ends of your hammer.  Set aside.  Hang the rose inside using fishing line.  Make sure to feed the wire down through the pipe. 



Test you rose and make sure it works!  Fill pipe top with silicone, the glue on your small sides. 





At the bottom, cut wire to length.  You don't want a bunch of excess.  Attach on/off switch and battery.  Create battery pack.  Make hole for switch.  My battery pack has a hole for the switch, but it was too close to where my hand would go, so I moved it up the handle.





Attach.




Use worbla to cover imperfections.  Ditto with instamorph.












Once satisfied, prime and paint.







And you're done!  If you have any problems or questions, feel free to ask!


Until next time, keep cosplaying!  Any questions, comments, or requests, leave them below!
Instagram
YouTube

No comments:

Post a Comment